WIP - French Cloudship on Mars

Ironclad Miniatures in the UK have a nifty small Martian Cloudship available that I'm modifying for use by the French on Mars.

To begin, the French colony doesn't have the ship building capacity which the British enjoy in Syrtis Major. With a limited ability to build modern aerial gunboats, the authorities in Idaeus Fons must improvise, and the French-Martian Colonial Airfleet is comprised mostly of native, wooden designs in French service.

Resin bits by Ironclad Miniatures

Since my cloudship was going to be retrofitted with steam, dans la méthode des Américains, I wanted extra space for the steam engine, so I replaced the deck supplied with a new deck, cut from light balsa and basswood. The lower hull will remain the same, save for the addition of an air-screw or two.

Miniatures by Askari

Depicted for the reader's gentle delectation are four French Naval artillerymen, from Askari Miniatures. I am debating placing a half-height deck house/covered hatch in the centre, but have yet to find a model I like....

- finis - 

Æronef vs. Ærial Gunboat

Discussion on The Miniatures Page encouraged me to descend into the crypt and dig out my old 25mm aerial gunboats.  These had been used for a single game of Sky Galleons of Mars back in the mid-to-late 90s.

Above is a comparison of the Ironclad Aeronef vs the smallest British "Aphid" - although I think I was building the "Penelope" as I note the plethora of Hotchkiss Revolving Cannon and a rather prominent ram.

These are made of card stock and foam core on blue DIY/Dow insulation board formers, with thin wood decking. Ship plans are available in GDWs "Cloudships and Gunboats", now available from Heliograph Publishing Inc.

I am a little embarrassed at the poor quality and lack of important detail on these scratchbuilt models - my only defense is, in may callow youth, I was rushing to finish and we only played once, because we had issues keeping the stands upright. 

Later on, a friend of mine welded the pipes to steel railway washers, which gave them more stability.  Adding a few more washers, usually of a larger size, also increased stability - though these stands shown are not yet safe for any kind of carpet. A larger 4" OD washer is needed.

Being older and wiser, nowadays I would use a flange and pipe arrangement, or else cut these from clear Lucite. I will probably exchange the black rods for clear Lucite ones.

"Look Sarge, he didn't even paint the stacks..."
"...typical..."

The current project will be to refinish this and bring it up to spec, along with several others that are currently languishing in mothballs.

- finis -

28mm Aerial Steam Launch from Ironclad Miniatures

Pictured is a 28mm aerial steam launch from Ironclad Miniatures - picked up by yr humble correspondent back in 2008 (have I mentioned lately that I work slowly?). This model holds a special nostalgia for me, as back when we played the Space:1889 RPG, our British Army player-characters operated from one of these, along with our new allies, the Royal Navy.

The reader may be amused when I write that I primed this model about a year ago, and that it has gone away with me on vacation with every intent to paint it at least twice, but I could not decide upon the colour scheme.

The problem I had was that the Royal Navy (of which Britain's fledgling Aerial Service is part) have peacetime and wartime livery for Her Majesty's Ships. Peacetime vessels are painted with black hulls and buff upper works, while wartime paint is a mid-to-light grey.

Ironclad Aerial Launch - pictured are two RAFM Historicals for scale.

In the end, I went with a very dark grey hull with light grey upperworks, adhering as it were to the wartime colours in the peacetime scheme. I don't know why, but it works for me. I also found some vertical pipe-stands used in some of our old 25mm Sky Galleons of Mars games from the 1990's, one of which made for a handy flying stand.

This is a resin-cast model that is a joy to assemble. There were almost no bubbles in the resin, and they were confined to the underside of the deck. Nicely detailed with just the right amount of rivets. It does weight a respectable amount, and I'm probably going to add a larger base to the pipe-stand supporting it.

Armament consists of a single 25mm Hotchkiss Revolving Cannon miniature by Richard Houston - now available again from The Virtual Armchair General. This is labelled as "37mm" which translates to the 1-lbr HRC in Soldier's Companion.  The weapon is swappable with other miniatures, such as a Nordenfelt or Gardner gun or even a rocket tube, which would make for quite a nasty surpise for a wooden, Martian ship.

Let that be a lesson to the three-toed, yellow pongos...

- finis -

Raid on Kraag Sagonaar - Partie La Troisième - Attack of the Sky Galleons

High Martian Sky Galleon moves to engage Meduse and Rapiere

 The raid was going well for the French - by turns 7/8, the Sapeurs Martiennes had secured a growing sample of le sirdique and had returned to the kite, Meduse.

Standing by to Repel Boarders

Furious flying Martians hurled themselves at the French for committing such eco-sacrilege, but again, Lebel and Hotchkiss cannon fire were able to break up the charging beastmen.

High Martian cloudships from nearby dependent clans began to arrive piecemeal via the board edges, and the French took the message and made ready to depart.

Almost on cue, the French kite took a random critical hit to the rudder - while facing exactly opposite their designated exit board edge. 

"Make fast and rig for towing!"

  

Without losing initiative, Colonel Montrie  brought Rapiere along side the stricken kite and grappled both ships together. 

He then made to tow the kite and her sirdique-wood cargo off board.

 

CLANG!

The High Martian players were not going to be so easily denied, as their heavy Hullcutter galley bore down on both French ships, a smaller Endtime galley attempted to ram the tow lines.

The ram was successful, but the towline held, and le Rapiere, bellowing smoke from her stack, made full steam for the French colony at Idaeus Fons.

The French Won!

Vive la France!

A Hullcutter lines up to ram

Down in Flames

Meduse under tow from Rapiere as the French exit

Post Game Thoughts:

The game was entertaining and amusing.  As I have mentioned previouly, the French play a bit differently than the British, with fragile-yet-heavily-armed indigenous troops stiffened by Marines. 

Losing le Rapiere would have shifted the result toward a French Defeat, as it is their only steel gunboat on Mars - the French players understood this, and were aware that they were never further from defeat than a lucky critical hit. 

The Martian cloudships arrived randomly over a two-turn period, and were positioned to surround the French aerial squadron, but were unable to coordinate, due mainly to the aggressive maneuvering of le Rapiere (and quite a bit of luck).

- Finis -